Battery Charging Procedure

 

  1. With the charger DC cord disconnected from the golf car charger receptacle, connect the AC power supply cord to an AC outlet designed to provide the proper AC voltage for the charger.
  2. Insert the charger DC plug into the golf car receptacle. When inserting the DC plug, align the raised guide on the plug with the guide slot in the receptacle and push straight in slowly.
  3. The charger will turn on two to five seconds later, after the lockout function activates. The control circuit lockout remains activated until the charger plug is disconnected from the golf car.
  4. If the charger can shut off by itself, the batteries will be fully charged. Overcharging and undercharging will normally be prevented.
  5. If the charger does not seem to be operating properly, or if the batteries seem weak, contact Sasser Golf Cars, Inc. Service Department at (919) 734-1045.

Before replacing the charger, however, reset the charger in case the failure was caused by a temporary situation. To reset charger power, take the following steps:

  1. Unplug the DC cord from the golf car.
  2. Unplug the AC power from the power source.
  3. Wait 30 seconds, then plug in the AC cord.
  4. Plug in the DC cord.